AdapterId 06336h AdapterName "Eicon.Diehl DIVA MCA Adapter" NumBytes 1 NamedItem Prompt "I/O Address Selection" choice "I/O Address 0200" pos[0] = 0000XXXXB io 0200h - 0207h choice "I/O Address 0220" pos[0] = 0001XXXXB io 0220h - 0227h choice "I/O Address 0240" pos[0] = 0010XXXXB io 0240h - 0247h choice "I/O Address 0260" pos[0] = 0011XXXXB io 0260h - 0267h choice "I/O Address 0280" pos[0] = 0100XXXXB io 0280h - 0287h choice "I/O Address 02A0" pos[0] = 0101XXXXB io 02A0h - 02A7h choice "I/O Address 02C0" pos[0] = 0110XXXXB io 02C0h - 02C7h choice "I/O Address 02E0" pos[0] = 0111XXXXB io 02E0h - 02E7h choice "I/O Address 0300" pos[0] = 1000XXXXB io 0300h - 0307h choice "I/O Address 0320" pos[0] = 1001XXXXB io 0320h - 0327h choice "I/O Address 0340" pos[0] = 1010XXXXB io 0340h - 0347h choice "I/O Address 0360" pos[0] = 1011XXXXB io 0360h - 0367h choice "I/O Address 0380" pos[0] = 1100XXXXB io 0380h - 0387h choice "I/O Address 03A0" pos[0] = 1101XXXXB io 03A0h - 03A7h choice "I/O Address 03C0" pos[0] = 1110XXXXB io 03C0h - 03C7h choice "I/O Address 03E0" pos[0] = 1111XXXXB io 03E0h - 03E7h Help "The adapter needs an I/O address configured where data is written to and read from the card. There are 16 different choices available in the range of 0200h-03E0h given in steps of 20h (32 bytes). For each base address only 8 addresses are for the I/O. For example if the adapter is configured for I/O-address 240h then the I/O-addresses 240h-247h are really used. Check the documentation and configuration for other installed cards in your computer to avoid conflicts." NamedItem Prompt "Interrupt-Level Selection" choice "Interrupt 2" pos[0] = XXXX100XB int 2 9 choice "Interrupt 3" pos[0] = XXXX000XB int 3 choice "Interrupt 4" pos[0] = XXXX001XB int 4 choice "Interrupt 10" pos[0] = XXXX101XB int 10 choice "Interrupt 11" pos[0] = XXXX110XB int 11 choice "Interrupt 12" pos[0] = XXXX111XB int 12 Help "The interrupts 2,3,4,10,11 and 12 are available. Interrupt sharing is possible on microchannel computers. However first the interrupt handlers have to be written for sharing interrupts and secondly the reaction time for an interrupt increases. Therefore it is recommended to use a single interrupt for each installed card. Check the documentation and configuration for other installed cards in your computer to avoid conflicts."