AdapterId 06446h AdapterName "3Com EtherLink/MC Ethernet Adapter" NumBytes 1 NamedItem Prompt "Enable/Disable Adapter" Choice " Adapter Enabled " pos[0]=XXXXXXX1b Choice " Adapter Disabled " pos[0]=XXXXXXX0b Help "This controls whether the adapter is enabled or not. Use the Enabled setting for normal use. Use the Disabled setting if you are not using the adapter and enabling it causes a conflict with another device." NamedItem Prompt "I/O Address Range" choice " 300 to 307 " pos[0]=XXXXX00Xb io 0300h-0307h choice " 1300 to 1307 " pos[0]=XXXXX01Xb io 1300h-1307h choice " 2300 to 2307 " pos[0]=XXXXX10Xb io 2300h-2307h choice " 3300 to 3307 " pos[0]=XXXXX11Xb io 3300h-3307h Help "Determines the range of i/o addresses used by EtherLink/MC. The addresses in this range cannot be used by another installed device." NamedItem Prompt "Interrupt Level" choice " Channel 3 " pos[1]=XXXX0100b INT 3 choice " Channel 7 " pos[1]=XXXX0010b INT 7 choice " Channel 9 " pos[1]=XXXX1000b INT 9 choice " Channel 12 " pos[1]=XXXX0001b INT 12 Help "Determines the interrupt level used by EtherLink/MC. This adapter's interrupt level can be shared with another device. You may be able to improve performance by selecting a level that is not used by any other device." NamedItem Prompt "Packet Buffer RAM Address Range" choice " 0C0000 to 0C5FFF " pos[0]=XXX00XXXb mem 0c0000h-0C5FFFh choice " 0C8000 to 0CDFFF " pos[0]=XXX01XXXb mem 0c8000h-0CDFFFh choice " 0D0000 to 0D5FFF " pos[0]=XXX10XXXb mem 0d0000h-0D5FFFh choice " 0D8000 to 0DDFFF " pos[0]=XXX11XXXb mem 0d8000h-0DDFFFh Help "Determines the range of RAM and ROM addresses used by EtherLink/MC. The addresses in this range cannot be used by any other installed device. The range represents 8K bytes of RAM addresses followed by 4K bytes of ROM addresses." NamedItem Prompt "Transceiver Type" choice "On-Board Transceiver (BNC)" pos[0]=XX0XXXXXb choice "External Transceiver (DIX)" pos[0]=XX1XXXXXb Help "Determines the type of transceiver connection used by EtherLink/MC. If you have a thin ethernet network and wish to connect using T connector, select On-Board. If you have a drop cable from an external transceiver and wish to attach to the adapter's 15 pin DIX connector, select External."